Up for sale is my beloved JG Bar10. What started as a fresh scratch build turned into a full blown Action Army monster. The parts used in this build are as follows:  JG BAR10 (Base rifle)  TM VSR 10 G Spec barrel with foam filled suppressor (makes it rather quiet.)  Action Army 430mm 6.01 tight bore inner barrel  Action Army hop up chamber (best hop up chamber around)  Action Army Teflon cylinder  Action Army spring guide with bearings  Action Army m150 spring  Action Army specialized trigger kit with blue piston  Maple Leaf diamond bucking  Maple Leaf concave nub  NC Star 3-9x40 scope  7x Magazines  Caldwell extendable bipod  I won't even list the prices on here. You can go check out evike and see the prices on there, just so you know I'm not lying :) To build a comparable rifle, it would cost you over $600!!  Literally the only things that are stock are the upper receiver, the stock, the charging handle, and that's about it. There is absolutely nothing left to upgrade on this gun. All performance parts have been upgraded with Action Army/Maple Leaf parts.  The good:  Shoots straight and accurate up to about 230ft with the hop up properly tuned and using 0.43 gram bbs.  Nothing left to build or upgrade. This is as good as it gets unless you want to spend a few hundred dollars and get PDI parts, but I generally outshoot and outrange all the other snipers/dmr/aegs on my home field.  The bad:  Needs new paint  Preferably new scope. I use a Swiss Arms 4x40 on my other rifle. Highly recommend it. $40 on Amazon.  Scratch on cylinder. Does not affect performance one bit. Just thought I should mention it. You can see it on the picture.  Lost a screw for the scope ring so I improvised. The screw doesn't exactly fit, but works just fine. That's really all I can think of. This build has seen maybe 4k shots through it, and I just replaced the bucking for this sale as well. The reason I am selling it is because I have two rifles with almost exactly the same parts. Why? I have absolutely no idea. This was actually my second rifle build, and I'm too attached to my first one so this one has to go hahaha.  Due to the size of the rifle, it will be broken down into smaller pieces to ship in order to conserve money. I highly recommend that the purchaser cleans the functioning parts of the rifle thoroughly before assembling as you never know what contaminates can get into the hop up/barrel/cylinder during shipping.  Any other questions? Let me know! Trades for Silverback SRS only. You pay shipping, I'll cover PayPal fees.