Shoot me a $ offer, or maybe something of equal value👀 read description fills please!!! STOCK G&P Stoner63 w/ Gate Titan mosfet, box mag wired to motor. Winds when the trigger is pulled. HAS SOME SMALL ISSUES, READ DESCRIPTION FULLY! INCLUDED: •G&P Stoner63 W/ gate titan •Viking Combative’s Customs “tier one” kit - m249 box mag adapter plate - stock butt pad - shorty carbon barrel kit w/ threads •Original 16” barrel w/ hardware attach •G&P 14mm+ suppressor for 16” barrel •MAG brand m249 box mag wired to jst - stoner box mag included, non working •Extra motor grip •Spare hopup parts HOPUP SETUP: •New hopup unit (old parts included) •Nemazu firefly flat hop nub •Prommy 6.03 300mm inner barrel •Prommy purple bucking MODIFICATIONS: •Chopped stock •Hopup block wired to the motor so the box mag winds when the trigger is pulled •Stippled motor grip (extra grip included) - drilled out some room for wires from hopup •Top rail for optic ISSUES: •motor is sitting too low it sounds like, but the adjustment screw is glued in place from the factory. It could just be the motor got jammed from all of the wires in the grip. It’s the stock G&p 120 motor •rear sight spring is broken, so it flops around when you run(I had it taped down) •small chip missing from bottom of the stock where the old sling plate was(pictured) •VCC barrel screws don’t 100% line up with the factory holes on the stoner body, but everything it’s lined up correctly and tightened to spec(also pictured) Hmu with any questions, pretty sure I got legit everything💀💀